1) The short answer: the fall window closed on October 15
- The ideal window is Sept. 1 to about Oct. 15. Colorado State Forest Service gives the reasoning: soil is still warm enough for roots to establish before winter, and cooler days let the tree put energy into roots instead of leaves.
- PlantTalk Colorado says finish by the end of October. That practical deadline is now behind us.
- Evergreens carry the most risk in fall — their needles stay exposed through winter, and some deciduous trees transplant less successfully in fall for the same reason.
- The Front Range's average first freeze lands around October 1 (CSU Colorado Climate Blog). Johnstown and Loveland are USDA zone 5b on the 2023 map.
2) When you can still plant, and when you should wait
- Ground not frozen + you can commit to winter watering = plant it. A November planting is not a mistake if it is managed.
- Ground frozen = stop. A hole forced into frozen ground leaves the root ball in a pocket of cold soil with air around it. Roots cannot spread into it.
- Evergreen, bare-root, or a large specimen = wait for spring. Bare-root stock has no root ball to protect it and no soil holding moisture against it.
3) Why Colorado is the one place fall planting is second best
This is the part most generic planting guides skip, and it is why a November planting here is riskier than the same planting in Ohio. CSU Extension describes Colorado fall and winter as dry air, low precipitation, little soil moisture, and fluctuating temperatures, with often little or no snow cover from October through March. Root systems can be injured or killed by long dry periods — and the failure mode is nasty, because affected plants may appear perfectly normal and resume growth in the spring, using stored food energy, then weaken and die in late spring or summer when temperatures rise.
A tree planted too late can look healthy in April, green out normally, and collapse in July when it cannot draw enough water to keep the canopy it committed to. That is why soil moisture before the ground freezes is the make-or-break step. See our Northern Colorado winter watering guide and first-frost lawn prep guide.
4) Two things to do before you buy a single plant
Get a soil test. Root-zone pH matters more for woody plants than for turf, and November is the easiest month to sample. CSU's soil lab, sampling method, and what the numbers mean are in our NoCo soil testing guide. A tree planted into untested soil is a guess.
Call 811 — before the delivery date, not after. Colorado law requires contacting Colorado 811 at least two full business days before any excavation. Colorado 811 explicitly lists landscaping, planting shrubs and trees, and driving landscaping stakes as work needing a locate request, and it is free. Their homeowner guidance says do not just rely on your landscaper to do it — if in doubt, contact 811 yourself.
5) How to plant it so it actually lives
- Find the trunk flare before you dig. Pull back soil from the top of the root ball if needed and look for the larger structural roots flaring outward, not the small thin roots. A new tree should not look like a telephone pole; the trunk should widen at the base into a skirt shape. Trees planted too deep limit root oxygen, which can kill the tree.
- Dig a saucer-shaped hole, two to three times wider than the root ball. Measure the depth from the bottom of the root ball to the base of the trunk flare, then dig that deep. The sloped sides give new roots room to grow.
- Shave the root ball. Remove roughly 1 to 1½ inches of soil from the outside and shape it roughly square, even if no circling roots are visible — it encourages fresh roots to grow outward. Cut large woody circling roots with hand pruners, facing the cut toward the hole.
- Backfill with the soil you dug out. Not bagged potting mix — a different texture creates problems with water movement and root growth. Pack a ring of soil firmly around the root ball, then gently tamp the rest. Water as you backfill to collapse air pockets.
- Mulch 3 to 4 inches deep, off the trunk. It holds moisture and keeps grass away, but contact between mulch and bark damages bark, and piling it over the root ball creates a mulch volcano.
- Water immediately after planting, then keep watering through winter.
6) Winter watering: the numbers, from CSU
- Trees: 10 gallons per inch of trunk diameter, per watering. Measure the trunk at 6 inches above ground level, so a 2-inch caliper tree needs about 20 gallons. Apply to many locations under the dripline and beyond, and let it soak to a depth of about 12 inches.
- Newly planted shrubs: 5 gallons, twice a month.
- Small established shrubs under 3 feet: 5 gallons monthly. Large established shrubs over 6 feet: 18 gallons monthly.
- Water only when air and soil temperatures are above 40°F, with no snow cover. Apply during midday so it soaks in before overnight freezing. A solid layer of ice lasting over a month can suffocate turf.
- Monitor and water about once or twice each month during extended dry spells. PlantTalk's practical trigger: if four weeks elapse without snow cover, water again.
- Do not run your sprinkler system in winter, and disconnect and drain hoses after use.
7) What to do in November if you are not planting yet
- Water what is already planted. The highest-value action available to you in November — and it protects trees and shrubs you have had for years, not just new ones.
- Test the soil. November is ideal: no lawn pressure, and you have time to act on the results before spring.
- Call 811 and pick the site, so the spring dig is a formality rather than a delay.
- Choose plants with the Front Range Tree Recommendation List — the joint list from CSU Extension, Denver Botanic Gardens, the Colorado Tree Coalition, CNGA, and the Colorado chapter of ASLA, built for this climate. CSU's guidance is blunt: there is no perfect tree, and a wrong-site tree costs more than it saves.
- Order for spring. Bare-root stock goes in mid-March to mid-June; container stock can go in from about mid-April through mid-June.
- If you are converting turf instead of planting a tree, our xeriscape conversion and turf rebate guide covers the local programs and the pre-approval step that disqualifies people who start early.
8) When hiring it out is worth it
The work is more demanding than it looks — locating the trunk flare, digging a proper saucer-shaped hole, shaving the root ball, backfilling without air pockets, mulching correctly. All of it rewards doing it right the first time. And nobody waters a new tree the way a crew does for the first two years.
Our Landscape Design & Install package runs $2,000–$8,000+ for a typical residential project, and includes an on-site consultation with a 3D design render, a plant palette tailored to NoCo conditions, soil prep, mulch and rock features, tree, shrub, and perennial installation, and a one-year plant establishment warranty. The design consultation is $150 and credited to the project if you proceed.
That warranty lines up with CSU's caliper rule more than it might seem: a tree needs about one year of root establishment per inch of caliper, so a one-year warranty covers first-year risk on a typical 1.5 to 2 inch caliper tree — exactly the size CSU recommends. It is also why new plantings need an irrigation plan, not just a hose. We handle sprinkler and irrigation alongside landscape installation, and our September irrigation prep guide covers the off-season work that makes spring startup cleaner.
Want a tree planted this season, or a plan for spring?
Call (970) 685-9512 or use our quick quote form. Send a photo of the spot and we will tell you honestly whether it is still a good month to dig, what should go there, and what it will take to keep it alive. We service Johnstown, Loveland, Berthoud, Fort Collins, Windsor, Greeley, Milliken, Timnath, Severance, Mead, Longmont, Evans, Firestone, Frederick, Eaton, and Ault.
